Lug Extension Kit
$49.00
Guarantee Safe Checkout
Description
Description
Lug Extension Kit – with 16mm bearings with pocket fillers, 30 tooth drive pulley and 20 lug extensions
There is one more thing about these sleds, they are not standard, up until now we have been limited to a 1/8 inch deep lug, these sleds have a 5/16 lug. See comparison product gallery.
16mm bearings with pocket fillers
The package includes this 30 tooth pulley, which will replace the stock 44 tooth drive pulley, this will give you an additional 20 % speed and allow the drive shaft to be lowered, now you can tackle powder snow.
You have to make sure both bearings are centered at the very bottom of the old bearing pocket, glue them in place when you have figured out where that is. Locktite super glue for rubber and plastic is a good choice of glue.
Lug Extensions
Presently your sled is designed to accommodate a 1/8 inch track, the gearless track a little more. In order to allow a deeper lug track we have to move the main drive pulley down. By inserting these spacers and smaller bearing you can lower the pulley by 3/16 of an inch. That’s the first step, by doing this your drive pulley attached to the small belt will not fit. What you will need is a 30 teeth drive pulley , listed on top of the page. The good news is this pulley will give you 25 % more speed then the stock pulley.Now comes the decision making part…if you have a transmission, there is no problem, you will pick up the extra speed automatically, if you have a direct drive sled you will need a 10 tooth pulley for the motor, and also a heat sink, the motor will overheat otherwise.
Additional information
Additional information
| Weight | 48 oz |
|---|
Reviews
There are no reviews yet.